Change engine oil and filter while engine is at normal operation temperature. Check transmission for leaks. Check rear axle for leaks. Visually check fuel tank, lines, and connections for leaks. Check condition, position, and mounting of exhaust system. Examine for leaks. Check power steering system for leaks. Check overall thickness of front and rear disc brake pads. Examine brake disc surfaces. Check steering for absence of play, condition of suspension track rods, front axle joints, steering linkage, and joint disc. Check front control arm bushing for wear. Check brake and clutch system connectors and lines for leaks, damage, and incorrect positioning. Adjust parking brake if necessary. Check all tire pressures correct if necessary. Check condition of tires (outer surfaces (left/right)), tread wear and pattern(rotate if necessary); Half-shafts; check for leaks at flexible boots. Read out diagnostic system Check engine cooling system/heater hose connections for leaks. Check coolant level and antifreeze protection level; add coolant if necessary. Check level of brake and clutch fluid in reservoir; add fluid if required. Check windshield washer fluid level and antifreeze protection. Fill up and/or correct if necessary. Reset Service Indicator. Check wiper and washer system(s); wiper blades(replace if necessary), washer jet positions Replace microfilter or Acc Cabin Filter.
Drain and refill your vehicle's crankcase with BMW approved oil. Install a new genuine BMW oil filter Check all other Fluid levels, and top off as necessary. Check and adjust tire pressure. Reset oil light
Lou S. gave our service a 5 star review on 3/12/2025
Drain and refill your vehicle's crankcase with BMW approved oil. Install a new genuine BMW oil filter Check all other Fluid levels, and top off as necessary. Check and adjust tire pressure. Reset oil light
Lorry G. gave our service a 5 star review on 3/3/2025
Change engine oil and filter while engine is at normal operation temperature. Check transmission for leaks. Check rear axle for leaks. Visually check fuel tank, lines, and connections for leaks. Check condition, position, and mounting of exhaust system. Examine for leaks. Check power steering system for leaks. Check overall thickness of front and rear disc brake pads. Examine brake disc surfaces. Check steering for absence of play, condition of suspension track rods, front axle joints, steering linkage, and joint disc. Check front control arm bushing for wear. Check brake and clutch system connectors and lines for leaks, damage, and incorrect positioning. Adjust parking brake if necessary. Check all tire pressures correct if necessary. Check condition of tires (outer surfaces (left/right)), tread wear and pattern(rotate if necessary); Half-shafts; check for leaks at flexible boots. Read out diagnostic system Check engine cooling system/heater hose connections for leaks. Check coolant level and antifreeze protection level; add coolant if necessary. Check level of brake and clutch fluid in reservoir; add fluid if required. Check windshield washer fluid level and antifreeze protection. Fill up and/or correct if necessary. Reset Service Indicator. Check wiper and washer system(s); wiper blades(replace if necessary), washer jet positions Replace microfilter or Acc Cabin Filter.
CAMSHAFT POSITION SOLENOID VALVE – Remove & Replace – All
TIMING COVER &/OR GASKET – Remove & Reseal
Joyce G. gave our service a 5 star review on 2/18/2025
Drain and refill your vehicle's crankcase with BMW approved oil. Install a new genuine BMW oil filter Check all other Fluid levels, and top off as necessary. Check and adjust tire pressure. Reset oil light
Sabrina M. gave our service a 5 star review on 2/11/2025
Service A is due at 10000 miles or 12 months, then every 20000 miles or 24 months. TIRE PRESSURE MONITORING SYSTEM SENSORS – ACTIVATE BRAKE FLUID – INSPECT – [In the event of fluid loss, determine cause and perform repair.] COOLANT LEVEL – INSPECT – [Check coolant level in coolant expansion tank.] ENGINE OIL – REPLACE ENGINE OIL FILTER – REPLACE SERVICE INTERVAL INDICATOR/DISPLAY – RESET – [Read out service data from instrument cluster and reset ASSYST PLUS service interval display. If the service/maintenance work has not, or has only partially been carried out after the ASSYST PLUS service interval display has been reset, the maintenance computer must be reset to its original settings.]
Hansi R. gave our service a 5 star review on 2/10/2025